Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC C0900 00: Device Voltage High - EBCMDiagnostic Fault Information
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
|---|---|---|---|---|
B+ | C0899 00 | C0899 00 | -- | -- |
Ground | -- | C0899 00 | -- | -- |
Typical Scan Tool Data
Circuit | Short to Ground | Open | Short to Voltage |
|---|---|---|---|
Operating Conditions: Ignition ON, Engine OFF. Parameter Normal Value: 12.60 V. | |||
B+ | 0.00 V* | 0.00 V* | -- |
*The scan tool will not communicate with the EBCM if the battery voltage is less than 7 V. | |||
Circuit/System Description
The electronic brake control module (EBCM) monitors the 12 V battery voltage level available for system operation. A high voltage condition prevents the system from operating properly.
Conditions for Running the DTC
The ignition is ON.
Conditions for Setting the DTC
The EBCM detects that the battery voltage is greater than 18 V.
Action Taken When the DTC Sets
| • | The antilock brake system (ABS), electronic brake force distribution (EBD), traction control system (TCS), and vehicle stability enhancement system (VSES) are disabled. |
| • | The ABS, BRAKE, traction off, and vehicle dynamics caution (VDC) warning indicators turn ON. |
| • | The ABS pump motor turns ON if the voltage is greater than 28 V. |
Conditions for Clearing the DTC
| • | The DTC will pass when the condition for setting the DTC is no longer present. |
| • | The EBCM clears a history DTC when the DTC does not fail in 100 consecutive ignition cycles. |
Diagnostic Aids
| • | This DTC could be set by overcharging with a battery charger or jump starting. |
| • | A high voltage DTC in multiple modules indicates a concern in the charging system. |
Reference Information
Schematic Reference
Antilock Brake System Schematics
Connector End View Reference
Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
- Engine running, accessories OFF, measure and record the battery voltage at the 12 V battery terminals. The voltage should be between 12.6 and 15.0 V.
- Observe the scan tool EBCM Battery Voltage Signal parameter. The reading should be between 12.6 and 15.0 V.
| ⇒ | If not within the specified range, refer to Charging System Description and Operation. |
| ⇒ | If greater than the specified range, replace the EBCM. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for EBCM replacement, setup and programming.
