Tools Required
| • | J 41103-1
Torque Converter Seal Puller Legs |
| • | J 41103-2
Torque Converter Seal Puller Bridge |
| • | J 41103-3
Torque Converter Seal Support Body |
- Insert the three
J 41103-1
puller legs under the Torque
Converter Seal (54).
- Insert the
J 41103-3
support body over the stator shaft (43).
- Insert the
J 41103-2
puller bridge over the
J 41103-3
support body. Connect the
J 41103-1
puller
legs into the slots on the
J 41103-2
bridge.
Important: The puller legs will damage the torque converter seal (54). Discard the torque converter seal (54) after removal.
- Tighten the forcing screw on the
J 41103-2
puller bridge until the
J 41103-1
puller legs remove the torque converter seal (54).
Special Tools
| • | J 41103-1 Torque Converter Seal Puller Legs |
| • | J 41103-2 Torque Converter Seal Puller Bridge |
| • | J 41103-3 Torque Converter Seal Support Body |
For equivalent regional tools, refer to
Special Tools.
- Insert the three
J 41103-1 puller legs
under the Torque Converter Seal (54).
- Insert the
J 41103-3 support body
over the stator shaft (43).
- Insert the
J 41103-2 puller bridge
over the
J 41103-3 support body
. Connect the
J 41103-1 puller legs
into the slots on the
J 41103-2 puller bridge
.
Note: The puller legs will damage the torque converter seal (54). Discard the torque converter seal (54) after removal.
- Tighten the forcing screw on the
J 41103-2 puller bridge
until the
J 41103-1 puller legs
remove
the torque converter seal (54).
