PRODUCTION BRAKE SYSTEM CHANGE MAY CAUSE HIGH BRAKE EFFORT

Model and Year: 1988 CORSICA, BERETTA

1988 Corsica and Beretta vehicles produced beginning with the following vehicle identification numbers (VIN) at the assembly plants listed will be equipped with a different brake master cylinder, brake booster assembly and brake caliper assemblies.

Assembly Plant Model VIN Breakpoints -------------- ----- --------------- Wilmington (Y) Corsica, Beretta lGlLT51W5JY560211

Linden (E) Corsica, Beretta lGlLV11W8JE555668

Parts Usage

The new caliper part numbers listed below must be used to service ALL 1988 Corsica and Beretta models.

The NEW brake booster and master cylinder part numbers listed in this bulletin MUST be used to service only those Corsica and Beretta models produced beginning with the VIN breakpoints provided.

NOTICE: VEHICLES BUILT PRIOR TO THE VIN BREAKPOINTS MUST BE SERVICED WITH THE OLD BRAKE BOOSTER AND BRAKE MASTER CYLINDER PART NUMBERS LISTED IN THIS BULLETIN. MIXING THE NEW BOOSTER AND MASTER CYLINDER PARTS WITH OLD PARTS ON EARLY BUILT (PRIOR TO VIN BREAKPOINTS) VEHICLES MAY RESULT IN A BRAKE APPLICATION REQUIRING INCREASED PEDAL TRAVEL TO STOP THE CAR.

Parts Information:

1988 New 1988 Old Part Number Part Number ----------- ----------- Caliper 18015752 (Left) 18011667 (Left) 18015753 (Right) 18011668 (Right)

Booster 18015498 (Code NT) 18013875 (Code LF)

Master Cylinder 18015760 (Code NT) 18014370 (Code DL)

Parts Identification:

The new brake booster part number listed in this bulletin can be identified by the broadcast code "NT" printed on the bar code label which is attached to the part. See Illustration, View A.

The new master cylinder part number listed in this bulletin can be identified by a broadcast code of "NT" stamped on the aluminum housing. See View C. The broadcast code of "NT" is also printed on the bar code label attached to the rear of the brake fluid reservoir, view B. The brake booster, master cylinder, and brake fluid reservoir MUST all have a broadcast code of "NT" on all vehicles built after the VIN breakpoints listed in this bulletin.

Use applicable Labor Operation Number and Labor Time.

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.