SOME OWNERS MAY COMMENT ON A NO START, BATTERY RUN DOWN OR BLOWN FUSE CONDITION.
SOME CONVERTIBLE MODELS WERE BUILT WITH A LOWER REVEAL TRIM SCREW WHICH IS TOO LONG (FIGURE 1). IN SOME INSTANCES WHEN THE SCREW WAS INSTALLED, THE SCREW PIERCED THE WIRE OR WIRES LEADING TO THE REAR DECK LID COMPARTMENT LAMP CAUSING THE CIRCUIT TO GROUND.
REMOVE OR DISCONNECT -
1. DISCONNECT NEGATIVE BATTERY TERMINAL.
2. REMOVE REAR COMPARTMENT LAMP BRACKET WITH DECK LID 2/3 UP.
3. REMOVE LOWER REVEAL TRIM SCREW (FIGURE 1).
4. CUT 5MM (1/4") OFF END OF SCREW.
5. REPAIR ANY DAMAGED WIRING. REFER TO SECTION 8A OF THE SERVICE MANUAL.
INSTALL OR CONNECT -
1. INSTALL LOWER REVEAL SCREW.
2. INSTALL REAR COMPARTMENT LAMP (WITH DECK LID 2/3 UP).
3. CHECK WIRES TO SCREW CLEARANCE.
FOR VEHICLES REPAIRED UNDER WARRANTY, USE:
LABOR OPERATION NUMBER: N6420 LABOR TIME: 0.5 HR. ADD: 0.2 HR. TO REMOVE BRACKET AND CUT SCREW
FIGURES: 1
GENERAL MOTORS BULLETINS ARE INTENDED FOR USE BY PROFESSIONAL TECHNICIANS, NOT A "DO-IT-YOURSELFER". THEY ARE WRITTEN TO INFORM THOSE TECHNICIANS OF CONDITIONS THAT MAY OCCUR ON SOME VEHICLES, OR TO PROVIDE INFORMATION THAT COULD ASSIST IN THE PROPER SERVICE OF A VEHICLE. PROPERLY TRAINED TECHNICIANS HAVE THE EQUIPMENT, TOOLS, SAFETY INSTRUCTIONS AND KNOW-HOW TO DO A JOB PROPERLY AND SAFELY. IF A CONDITION IS DESCRIBED, DO NOT ASSUME THAT THE BULLETIN APPLIES TO YOUR VEHICLE, OR THAT YOUR VEHICLE WILL HAVE THAT CONDITION. SEE A GENERAL MOTORS DEALER SERVICING YOUR BRAND OF GENERAL MOTORS VEHICLE FOR INFORMATION ON WHETHER YOUR VEHICLE MAY BENEFIT FROM THE INFORMATION.
COPYRIGHT 1994 GENERAL MOTORS CORPORATION. ALL RIGHTS RESERVED.