Removal Procedure
- Disconnect the negative battery cable.
- Raise the vehicle. Support the vehicle. Refer to General Vehicle Lifting and Jacking in General Information.
- Remove the right front tire and the wheel assembly. Refer to Wheel Removal in Tires and Wheels.
- Remove the right front splash shield.
- Remove the transmission brace bolts.
- Remove the transmission brace.
Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.
Installation Procedure
- Install the transmission brace.
- Install the transmission brace to engine bolts.
- Install the transmission brace to transmission bolts.
- Install the right front splash shield.
- Install the right front tire and the wheel assembly. Refer to Wheel Installation in Tires and Wheels.
- Lower the vehicle.
- Connect the negative battery cable.
Tighten
Tighten the bolts to 66 N·m (49 lb ft).
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
