Application | N·m | Lb Ft | Lb In. |
|---|---|---|---|
Balance Shaft Cover Nut and Bolt | 13 | -- | 115 |
Balance Shaft Driven Sprocket Bolt (left hand thread) | 30 + 45° | 22 + 45° | -- |
Balance Shaft to Housing Bolts 8 mm hex plus 45° | 10 | 11 | -- |
Balance Shaft Housing Bolts at 10 mm hex plus 40° | 15 | 11 | -- |
Balance Shaft to block Bolts at 13 mm hex | 25 | 18 | -- |
Balance Shaft to block Bolts at 15 mm hex | 53 | 39 | -- |
Balance Shaft to Block Bolts at 18 mm hex | 40 + 60° | 30 + 60° | -- |
Camshaft (exhaust) Rear Cover | 14 | -- | 124 |
Camshaft Position Sensor Bolt | 10 | -- | 89 |
Camshaft Sprocket to the Camshaft Bolt | 70 | 52 | -- |
Connecting Rod Nuts | 25 + 80° | 18 + 80° | -- |
Coolant Bleeder Valve | Fully Driven, Seated , Not Stripped | ||
Coolant Outlet to Cylinder Head | 26 | 19 | -- |
Coolant Pump to the Timing Chain Housing | 26 | 19 | -- |
Coolant Pump to the Coolant Pump Cover | 14 | -- | 124 |
Coolant Pump Cover to the Block | 26 | 19 | -- |
Crankshaft Balancer to the Crankshaft | 175 + 90° | 129 + 90° | -- |
Crankshaft Bearing Cap Bolts | 20 + 90° | 15 + 90° | -- |
Crankshaft Position Sensor to Block | 9 | -- | 80 |
Cylinder Head Bolts | Refer to Procedure | ||
Cylinder Head Threaded Plug | 26 | 19 | -- |
EGR Pipe to the EGR Adapter | 26 | 19 | -- |
Engine Coolant Air Bleed Pipe | 14 | -- | 124 |
Engine Coolant Air Bleed Pipe Nut | 42 | 31 | -- |
Engine Coolant Temperature Sensor to the Coolant Outlet | 11 | -- | 97 |
Engine Coolant Temperature Gauge Sensor to the Cylinder Head | Fully Driven, Seated, Not Stripped | ||
Engine Lift Bracket | 96 | 68 | -- |
Engine Mount Bracket Adapter to Block Bolt for the J Car Manual Trans | 60 + 60° | 44 + 60° | -- |
Engine Mount (right hand side) to the Engine Mount Bracket Bolts | 62 | 46 | -- |
Engine Mount (right hand side) to the Body Support Nut | 44 | 32 | -- |
Engine Mount (right hand side) to the body support bolt | 66 | 49 | -- |
Engine Mount Strut | 102 | 88 | -- |
Engine Mount Strut Bracket Front Bolts | 66 | 49 | -- |
Engine Mount Strut Bracket Bottom Bolts | 130 | 96 | -- |
EVAP Canister Purge Valve Solenoid Bracket Bolt | 8 | -- | 72 |
Exhaust Manifold Upper Heat Shield to the Manifold Bolts | 26 | 19 | -- |
Exhaust Manifold to the Cylinder Head Nuts | 42 | 31 | -- |
Exhaust Manifold to the Cylinder Head Studs | 11 | -- | 97 |
Exhaust Manifold Brace to the Exhaust Manifold Bolt | 56 | 41 | -- |
Exhaust Manifold Brace to the Oil Pan Nuts | 26 | 19 | -- |
Flywheel to Clutch Cover | 20 + 45° | 15 + 45° | -- |
Flywheel to the Converter | 63 | 46 | -- |
Flywheel to the Crankshaft | 30 + 45° | 22 + 45° | -- |
Front Cover to the Timing Chain Housing | 12 | -- | 106 |
Fuel Pipe Bracket to the Camshaft Housing | 15 | 11+30° | -- |
Fuel Pipe to the Fuel Rail Nut | 30 | 22 | -- |
Fuel Rail to the Camshaft Housing | 26 | 19 | -- |
Ignition Coil and Module Assembly to the Camshaft Housings | 22 | 16 | -- |
Intake Manifold Brace Bolts | 47 | 35 | -- |
Intake Manifold Brace Bolts, Second Set | 24 | 18 | -- |
Intake Manifold to the Cylinder Head Bolts/Nuts | 26 | 19 | -- |
Intake Manifold to the Cylinder Head Studs | 11 | -- | 97 |
Knock Sensor | 20 | 15 | -- |
MAP Sensor to the Intake Manifold | 10 | 89 | 27 |
Oil Filter Connector to the Block | 29 | 21 | -- |
Oil Fill Tube Bolt/Screw | 8 | -- | 71 |
Oil Filter to the Block | 3/4 to one complete turn after gasket contact | ||
Oil Level Switch to the Oil Pan | 40 | 30 | -- |
Oil Pan Bolts | 24 | 18 | -- |
Oil Pan Bolts, Second Set | 12 | -- | 106 |
Oil Pan Drain Plug | 26 | 19 | -- |
Oil Pan Studs | 26 | 19 | -- |
Oil Passage Plugs, Block 1/8x27 | 10 | -- | 89 |
Oil Passage Plugs, 3/8x18 | 30 | 22 | -- |
Oil Passage Plugs, 1/4x18 | 20 | 15 | -- |
Oil Passage Plug Bolt | 30 | 22 | -- |
Oil Pump to the Balance Shaft Housing | 12 | -- | 106 |
Oil Pump to the Balance Shaft Housing | 10 | -- | 89 |
Oil Pump to Block | 54 | 40 | -- |
Power steering Pipe to the Pump Nut | 27 | 20 | -- |
Power steering Pump to the Cam Carrier Bolts | 26 | 19 | -- |
Rear Crankshaft Seal Housing to Block | 12 | -- | 106 |
Spark Plugs to the Cylinder Head | 18 | 13 | -- |
Starter to the Block Bolt | 96 | 71 | -- |
Starter to the Transmission Bolt | 96 | 71 | -- |
Tensioner to Tensioner Bracket Nut | 54 | 40 | -- |
Timing Chain Housing to the Camshaft Housings | 26 | 19 | -- |
Timing Chain Housing to the Block Bolts/Studs | 29 | 21 | -- |
Timing Chain Tensioner to Housing and Block | 10 | -- | 89 |
Throttle Body to the Intake Manifold | 10 | -- | 89 |
Thrust Plate to the Balance Shaft Housing | 13 | -- | 115 |
Transmission to the Block Bolt | 54 | 40 | -- |
Transmission to the Block Nut | 56 | 41 | -- |
Transmission to the Block Stud | 13 | -- | 115 |
