- Install oil filter bypass valve.
• | Insert a new oil filter bypass valve in the cylinder block |
• | Use a center punch to stake the valve in three places. |
- Install the oil filter connector.
Tighten
Tighten the oil filter connector to 29 N·m (21 lb ft).
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install a new oil filter.
• | Lubricate the oil filter seal with clean engine oil before installation. |
• | Tighten the oil filter 3/4 to one full turn after the gasket contacts
the cylinder block. |