- Connect any spark plug boot connector assembly that stuck to a spark plug onto the ignition coil and module assembly.
- Locate the ignition coil and module assembly over the spark plugs and push straight down.
- Clean any loose lubricant that is present on the ignition coil and module assembly to the camshaft housing bolts.
- Apply Pipe Sealant GM P/N 1052080 or equivalent onto the ignition coil and module cover assembly to the camshaft housing bolts.
- Install the camshaft housing bolts.
Important: Hand start the ignition coil and module assembly to camshaft housing bolts.
Tighten
Tighten the bolts to 22 N·m (16 lb ft).
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
