Shift Control Assembly

1. Disconnect the negative battery cable. Refer to

   Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

   in General Information.



2. Remove the following parts from the shift control:

2.1.

The knob

2.2.

The boot

2.3.	The front console

3. Remove the shift cables from the pin on the shift control.
4. Remove the spring clip holding the cables to the shift control.
5. Remove the shift control.

1. Install the shift control.
2. Install the shift control nuts.

Tighten
Tighten the nuts to 25 N·m (18 lb ft).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the shift cables to the pin on the shift control.
4. Install the spring clip that holds the cables to the shift control.
5. Install the following parts on the shift control assembly:

5.1.	The front console

5.2.

The boot

5.3.

The knob

6. Connect the negative battery cable.