SOME OWNERS MAY COMMENT ON A RATTLE/SQUEAK COMING FROM THE PASSENGER (RIGHT) SIDE OF THE REAR FOLDING SEATBACK AREA WHEN THE REAR SEAT IS UNOCCUPIED.
THE CONDITION MAY BE DUE TO EXCESSIVE CLEARANCE BETWEEN THE REAR SEATBACK FRAME AND BODY PIVOT BRACKETS.
TO CORRECT THIS CONDITION, REMOVE REAR SEATBACK AND REPOSITION THE RIGHT HAND FRAME ARM AS FOLLOWS:
1. REMOVE REAR SEATBACK. REFER TO REAR SEATBACK IN THE APPROPRIATE SERVICE MANUAL.
2. REPOSITION RIGHT HAND FRAME ARM BY MOVING OUTBOARD APPROXIMATELY 8 MM (0.31 IN.). CHECK THE NEW MINIMUM WIDTH DIMENSION OF 1086 MM (42.75 IN.) FROM THE LEFT HAND FRAME ARM TO THE RIGHT HAND FRAME ARM. REFER TO FIGURE 1.
3. INSTALL REAR SEATBACK. REFER TO REAR SEATBACK IN THE APPROPRIATE SERVICE MANUAL.
FOR VEHICLES REPAIRED UNDER WARRANTY, USE:
LABOR OPERATION NUMBER: C7188 LABOR OPERATION TIME: 0.2 HR
FIGURES: 01 ATTACHMENTS: 00
FIGURE 1: 1. ORIGINAL POSITION OF RIGHT HAND FRAME ARM. 2. NEW (REVISED) POSITION OF RIGHT HAND FRAME ARM. 3. REAR SEATBACK.
GENERAL MOTORS BULLETINS ARE INTENDED FOR USE BY PROFESSIONAL TECHNICIANS, NOT A "DO-IT-YOURSELFER". THEY ARE WRITTEN TO INFORM THOSE TECHNICIANS OF CONDITIONS THAT MAY OCCUR ON SOME VEHICLES, OR TO PROVIDE INFORMATION THAT COULD ASSIST IN THE PROPER SERVICE OF A VEHICLE. PROPERLY TRAINED TECHNICIANS HAVE THE EQUIPMENT, TOOLS, SAFETY INSTRUCTIONS AND KNOW-HOW TO DO A JOB PROPERLY AND SAFELY. IF A CONDITION IS DESCRIBED, DO NOT ASSUME THAT THE BULLETIN APPLIES TO YOUR VEHICLE, OR THAT YOUR VEHICLE WILL HAVE THAT CONDITION. SEE A GENERAL MOTORS DEALER SERVICING YOUR BRAND OF GENERAL MOTORS VEHICLE FOR INFORMATION ON WHETHER YOUR VEHICLE MAY BENEFIT FROM THE INFORMATION.
COPYRIGHT 1997 GENERAL MOTORS CORPORATION. ALL RIGHTS RESERVED.