Temperature Control Cable Replacement for Chevrolet Cavalier 1998

Temperature Control Cable Replacement Pontiac

The temperature control cable is attached to the right of the HVAC module heater case.

1. Remove the right sound insulator panel.
2. Disconnect the cable from the module.



3. Remove the accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement in Instrument Panel, Gauges and Console.
4. Remove the heater and A/C control (1). Pull the heater and A/C control rearward.
5. Disconnect the cable from the heater and A/C control (1).

1. Connect the cable to the heater control.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the heater and A/C control to the instrument panel.

Tighten
Tighten the screws to 2 N·m (18 lb in).




3. Install the accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement in Instrument Panel, Gauges and Console.
4. Connect the cable to the module.
5. Install the right sound insulator panel.

Temperature Control Cable Replacement Chevrolet

The temperature control cable is attached to the right of the HVAC module heater case.

1. Remove the right sound insulator panel.
2. Disconnect the cable from the module.
3. Remove the accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement in Instrument Panel, Gauges and Console.



4. Remove the heater and A/C control (1). Pull the heater and A/C control rearward.
5. Disconnect the cable from the heater and A/C control (1).

1. Connect the cable to the heater and A/C control (1).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the heater control (1) to the instrument panel.

Tighten
Tighten the screws to 2 N·m (18 lb in).

3. Install the accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement in Instrument Panel, Gauges and Console.
4. Connect the cable to the module.
5. Install the right sound insulator panel.