GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Raise and suitable support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the oil pan drain bolt.

  3. Object Number: 189001  Size: SH
  4. Remove the oil filter.

Installation Procedure


    Object Number: 189001  Size: SH
  1. Install the oil filter.
  2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the oil pan drain bolt.
  4. Tighten
    Tighten the oil pan drain bolt to 26 N·m (19 lb ft).

  5. Lower the vehicle.
  6. Fill the engine with oil to the appropriate mark.
  7. Start engine and inspect for leaks.