For 1990-2009 cars only
Removal Procedure
- Raise the vehicle. Support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Place the drain pan under the transaxle oil pan.
- Remove the oil pan bolts from only the front and the sides.
- Loosen the rear oil pan bolts about 4 turns.
- Lightly tap the oil pan with a rubber mallet or pry in order to allow the fluid to drain.
- Remove the remaining oil pan bolts.
- Remove the oil pan.
- Remove the oil pan gasket.
Notice: When removing the oil pan bolts, be careful not to damage the oil pan sealing surfaces. Such damage may result in oil leaks in this area.
Installation Procedure
- Clean and inspect the oil pan for dents or damage. Dry the oil pan before installation.
- Install the oil pan gasket. Use a new gasket if the sealing ribs are damaged.
- Install the oil pan. Replace the bottom pan if damaged.
- Install the oil pan attaching bolts.
- Lower the vehicle.
- Fill the transmission. Refer to Fluid Capacity Specifications .
- Inspect the transmission fluid level. Refer to Transmission Fluid Check
- Inspect the oil pan gasket for leaks.
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the bolts to 12 N·m (106 lb in).
