1. Remove the shift linkage.
2. Disconnect the electrical connector.



3. Remove the park/neutral position switch mounting bolts.



4. Remove the park/neutral position switch assembly.

Using Old Switch

1. Place the shift shaft in N (Neutral).
2. Align the flats of the shift shaft with the switch.




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the park/neutral position switch mounting bolts.

Tighten
Tighten the bolts to 24 N·m (18 lb ft).

Important: Ensure that the engine will only start in the P (Park) or the N (Neutral) position. Readjust the switch if the engine will start in any other position.

4. Turn the ignition switch to the ON position.