Tools Required

J 41352 Modular Column Holding Fixture

1. Install the ignition switch assembly (1).
2. Install the 2 tapping screws (2).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

Tightens
Tighten the screws to 1.5 N·m (13 lb in).




3. Install all wire harness straps to the wire harness assembly.
4. Remove the steering column and J 41352 from the vise.