Tools Required

J 41352 Modular Column Holding Fixture

Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:

•	Air bag deployment

•	Personal injury

•	Unnecessary SIR system repairs

In order to avoid the above conditions, observe the following guidelines:

•	Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring.

•	If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System.

1. Disable the inflatable restraint steering wheel module. Refer to Disabling the SIR System in SIR.
2. Remove the steering wheel from the steering column. Refer to Steering Wheel Replacement .
3. Remove the tilt lever. Refer to Tilt Lever Replacement - On Vehicle .
4. Remove the trim covers. Refer to Steering Column Trim Covers Replacement - On Vehicle .
5. Remove the steering column from the vehicle. Refer to Steering Column Replacement .
6. Inspect the steering column for accident damage. Refer to Steering Column Accident Damage Inspection - Off Vehicle .
7. Install the steering column and J 41352 into a vise.



8. Tilt the column in the UP position

Caution: The tilt spring and the spring guide are under pressure. The tilt spring and the spring guide may become a projectile. Secure the spring with locking pliers during removal. Secure the spring with locking pliers during installation. Bodily injury may result during removal and installation of the tilt spring and the spring guide. Always use caution during removal and installation of the tilt spring and the spring guide.

9. Apply pressure onto the spring retainer (3).
10. Turn the spring retainer (3) clockwise and release to remove the spring retainer (3).
11. Remove the tilt spring (2) and the spring guide (1).
12. Remove the spring guide (1) from the tilt spring (2).