1. Remove the door jamb.
2. Disconnect the door jamb switch electrical connector.
3. Remove the door jamb switch from the vehicle door pillar.

Important: When a new jamb switch is installed and the door is closed the first time, the plunger is forced into the sleeve and automatically adjusts the jamb switch for that particular door. If a jamb switch fails, do not readjust the switch. Install a new jamb switch.

1. Position the door jamb switch by the pillar.
2. Connect the door jamb switch electrical connector.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the door jamb switch (2).

Tighten
Tighten the door jamb switch to 10 N·m (89 lb in).