Parking and Turn Signal Lamp Replacement Pontiac

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Remove the bulb/socket from the park and turn lamp.
3. Remove the bulb from the socket.
4. Remove the nuts (2) from the park turn lamp.
5. Remove the park turn lamp (1) from the front bumper fascia.

1. Install the park turn lamp (1) to the front bumper fascia.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the nuts (2) to the park turn lamp.

Tighten
Tighten the park turn lamp nuts to 2 N·m (18 lb in).

3. Install the bulb to the socket.
4. Install the bulb/socket to the park and turn lamp.
5. Lower the vehicle.

Parking and Turn Signal Lamp Replacement Chevrolet

1. Remove the hood close out filler panel. Refer to Hood Close Out Filler Replacement in Body Front End.
2. Insert a flat-bladed tool thought the rectangle slot in the headlamp bracket.
3. Apply outboard pressure to the locking tab (3) while guiding the parking lamp forward.
4. Apply pressure to the outboard locking tab (1) while guiding the parking lamp forward.
5. Remove the parking lamp from the vehicle.
6. Disconnect the bulb/socket (2) from the parking lamp.
7. Remove the bulb from the socket, if required.

1. Install the bulb to the socket, if required.
2. Connect the bulb/socket (2) to the parking lamp.
3. Position the parking lamp inboard mounting pins (3) to the headlamp mounting retainers and the outboard locating tab (1) to the fender retainer.
4. Install the parking lamp, pressing into place until fully seated.