GM Service Manual Online
For 1990-2009 cars only

Test Description

The numbers below refer to the step numbers on the diagnostic table.

  1. Lack of communication may be due to a partial malfunction of the class 2 serial data circuit or due to a total malfunction of the class 2 serial data circuit. The specified procedure will determine the particular condition.

  2. The presence of DTCs which begin with U indicate some other module is not communicating. The specified procedure will compile all the available information before tests are performed.

Step

Action

Yes

No

1

Install a scan tool.

Does the scan tool power up?

Go to Step 2

Go to Scan Tool Does Not Power Up in Data Link Communications

2

  1. Turn ON the ignition, with the engine OFF.
  2. Attempt to establish communication with the body control module.

Does the scan tool communicate with the body control module?

Go to Step 3

Go to Scan Tool Does Not Communicate with Class 2 Device in Data Link Communications

3

Select the display DTCs function on the scan tool for the following modules:

    • Body Control Module
    • Powertrain Control Module

Does the scan tool display any DTCs?

Go to Step 4

Go to Symptoms - Doors

4

Does the scan tool display any DTCs which begin with a U?

Go to Scan Tool Does Not Communicate with Class 2 Device in Data Link Communications

Go to Step 5

5

Does the scan tool display DTC B1000, B1001, B1372 or B1382?

Go to Diagnostic Trouble Code (DTC) List in Body Control System

Go to Step 6

6

Does the scan tool display any DTCs which begin with a P?

Go to Diagnostic Trouble Code (DTC) List in Engine Controls

Go to Step 7

7

Does the scan tool display one of the following DTCs?

    • DTC B3127
    • DTC B3132
    • DTC B3133
    • DTC B3137
    • DTC B3138

Go to Diagnostic Trouble Code (DTC) List

Go to Symptoms - Doors