For 1990-2009 cars only
Removal Procedure
- Insert a small flat-bladed tool between the 2 halves of the transmitter case (6,4) at the slot provided near the key ring (5) hole.
- Twist the tool in order to open the case.
- Remove the battery (2).
Installation Procedure
- Install the battery (2) with the positive (+) side facing down.
- Ensure the transmitter case seal is in the proper position.
- Align the 2 halves of the transmitter case (6,4).
- Snap the 2 halves of the transmitter case together.
- Test the operation of the transmitter. Refer to Transmitter Synchronization .
Use one 3-volt CR2032 battery or the equivalent.
Important: Normal battery life is approximately 2 years. Replace the batteries when the range of the transmitter begins to decrease significantly to less than approximately 7 m (23 ft).
