- Remove the left instrument panel insulator.
Refer to
Instrument Panel Insulator Replacement
in Instrument Panel, Gauges
and Console.
- Disconnect the wiring harness connector(s) from the
brake release switch.
- Pull the brake release switch rearward in order to remove the
switch from the retainer.
Installation Procedure
- Install the brake release switch retainer
into the bracket (from the forward side).
- With the brake pedal depressed, insert the switch into the retainer
until the switch seats on the retainer. You may hear audible "clicks"
as the ribbed portion of the switch pushes forward through the retainer.
- Connect the wiring harness connector(s) to the brake release switch.
- Adjust the brake release switch in the
following manner:
| 4.1. | Pull the brake pedal fully rearward against the pedal stop until
you can not hear audible "clicks". The brake release switch moves
in the retainer. This movement provides adjustment. |
| 4.2. | Release the brake pedal. Repeat the above steps in order to ensure
that you have properly adjusted the switch. |
- Install the left instrument panel insulator. Refer to
Instrument Panel Insulator Replacement
in Instrument Panel, Gauges and Console.
