Removal Procedure
- Peel the weatherstrip
from the pinch weld flange. Move the weatherstrip in the following direction:
1.1. | Toward the lower corners |
1.2. | Around the complete opening |
- Clean all of the adhesive from the pinch-weld flange.
Installation Procedure
- Apply a bead of weatherstrip
adhesive GM P/N 12345096 to the following areas:
1.1. | The edge of the pinch-weld flange |
1.2. | Around the entire perimeter of the rear compartment opening |
- Install the center of the weatherstrip onto the gutter flange.
Begin at the forward center of the opening between the hinge arms.
- Push down by hand on the weatherstrip over the entire area until
fully seated.