Parking and Turn Signal Lamp Replacement Pontiac

1. Open the hood.
2. Remove the hood close out filler panel. Refer to Hood Close Out Filler Replacement in Body Front End.



3. Remove the park/turn signal bulb/socket by depressing the lock tab and rotating the bulb/socket counterclockwise.



4. Remove the bolt that retains the park/turn signal lamp bracket to the upper tie bar.
5. Remove the screw that retains the grille assembly to the fascia.

Remove the park/turn lamp housing with the grille assembly from the vehicle.




6. Drill out the rivet from the grille to the lamp assembly.



7. Remove the bolts/screws that retain the grille assembly to the park/turn lamp assembly.
8. Remove the bolts that retain the park/turn signal lamp assembly from the lamp.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

1. Install the bolts/screws to retain the park/turn signal lamp assembly to the park/turn lamp.

Tighten
Tighten the bolts/screws to 2 N·m (18 lb. in)

2. Install the bolts/screws to retain the grille assembly to the park/turn lamp.

Tighten
Tighten the bolts/screws to 2 N·m (18 lb. in)




3. Install the rivet that secures the grille to the park/turn lamp assembly.



4. Position the park/turn lamp housing with the grille assembly to the vehicle.
5. Install the bolt that retains the park/turn signal lamp bracket to the upper tie bar.

Tighten
Tighten the bolt to 10N·m (89 lb in)

6. Install the screw that retains the grille assembly to the fascia.



7. Install the park/turn signal bulb/socket by depressing the lock tab and rotating the bulb/socket clockwise.
8. Install the hood close out filler panel. Refer to Hood Close Out Filler Replacement in Body Front End.
9. Close the hood.