Backup Lamp Replacement Pontiac

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.



2. Remove the bulb/socket from the backup lamp.



3. Remove the bulb from the socket, if required.



4. Remove the nuts from the backup lamp.



5. Remove the backup lamp from the rear bumper fascia.

1. Position the backup lamp to the rear bumper fascia.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.




2. Install the nuts to the backup lamp.

Tighten
Tighten the backup lamp nuts to 2 N·m (18 lb in).




3. Install the bulb to the socket, if required.



4. Install the bulb/socket to the backup lamp.
5. Lower the vehicle.

Backup Lamp Replacement Chevrolet

1. Open the rear compartment.
2. Remove the bulb/socket from the backup lamp.
3. Remove the bulb from the socket, if required.

1. Install the bulb to the socket, if required.
2. Install the bulb/socket to the backup lamp.
3. Connect the electrical connector to the backup lamp.
4. Position the backup lamp to the rear compartment lid.
5. Close the rear compartment.