Tools Required
J 38841 Crankshaft Rear Oil Seal
Installer
- Apply engine oil to the inside and outside
diameter of the new crankshaft rear oil seal.
- Slide the crankshaft rear oil seal over the mandrel until the
back of the crankshaft rear oil seal bottoms squarely against the collar of
the tool.
- Install the crankshaft rear oil seal.
| 3.1. | Align the dowel pin of J 38841
with
the dowel pin in the crankshaft. |
| 3.2. | Attach the J 38841
to the
crankshaft by hand or tighten attaching screws to 5 N·m (45 lb in). |
| 3.3. | Turn the T-handle of J 38841
so
the collar pushes the seal into the bore. |
Turn the handle until the collar is tight against the case. Ensure the
seal is seated properly.
| 3.4. | Loosen the T-handle until it comes to a stop. |
| 3.5. | Remove the attaching screws. |
