1. Remove the oil level indicator from the oil level indicator tube.
2. Remove the oil level indicator tube mounting bolt.
3. Remove the left tire and rim from the vehicle. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
4. Remove the left front fender wheelhouse splash shield panel from the vehicle. Refer to Wheelhouse Panel Replacement in Body Front End.
5. Remove the oil level indicator tube retaining clip.



6. Remove the oil level indicator tube from the oil pan.
7. Remove the O-ring from the oil level indicator tube.

Important: Always use a NEW O-ring seal when installing the oil level indicator tube.

1. Apply a small amount of clean engine oil on the end of the oil level indicator tube.
2. Install the O-ring seal on the oil level indicator tube into the oil pan.



3. Install the oil level indicator tube to the engine.
4. Install the oil level indicator tube retaining clip.
5. Install the left tire on the vehicle. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
6. Install the wheel house splash shield panel. Refer to Wheelhouse Panel Replacement in Body Front End.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

7. Install the mounting bolt to the retaining bracket.

Tighten
Tighten the bolts to 4 N·m (35 lb in).

8. Install the oil level indicator in the oil level indicator tube.