Tools Required
J 43013 Fuel Injector
Remover
Removal Procedure
Notice: Use care in removing the fuel injectors in order to prevent damage to
the fuel injector electrical connector pins or the fuel injector nozzles.
Do not immerse the fuel injector in any type of cleaner. The fuel injector
is an electrical component and may be damaged by this cleaning method.
Important: The engine oil may be contaminated with fuel if the fuel injectors are
leaking.
- Remove the fuel rail assembly. Refer to
Fuel Injection Fuel Rail Assembly Replacement
.
- Remove the injector retainer
clip (4).
- Insert the fork of J 43013
the fuel injector assembly removal tool between the fuel rail
pod and the 3 protruding retaining clip ledges. Use a prying motion while
inserting the tool in order to force the injector out of the fuel rail pod.
- Discard the injector retainer
clip (1).
- Remove the injector O-ring seals (2), (4) from both ends
of the injector. Discard the O-ring seals.
Installation Procedure
Important: When ordering new fuel injectors, be sure to order the correct injector
for the application being serviced.
The fuel injector assembly (1) is stamped with a part number identification
(2). A four digit build date code (3) indicates the month (4), day (5),
year (6), and the shift (7) that built the injector.
- Lubricate the new injector
O-ring seals (2), (4) with clean engine oil.
- Install the new injector O-ring seals on the injector.
- Install a new retainer clip (1) on the injector.
- Push the fuel injector (5)
into the fuel rail injector socket with the electrical connector facing outwards.
The retainer clip (4) locks on to a flange on the fuel rail injector
socket.
- Install the fuel rail assembly. Refer to
Fuel Injection Fuel Rail Assembly Replacement
.