Removal Procedure
- Drain the fuel below the level of the fuel filler hose. Refer to Fuel Tank Draining .
- Remove the fuel fill pipe housing to fuel fill pipe bolts.
- Remove the fuel fill pipe ground strap screw.
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Disconnect the fuel fill hose from the fuel tank.
- Disconnect the vent hose from the fuel tank.
- Remove the fuel fill (2) and vent pipe and hose (1) assembly.
- Cap the open end of the fuel tank.
Installation Procedure
- Uncap the fuel tank.
- Install the fuel fill (2) and vent pipe and hose (1) assembly to the fuel tank.
- Align the fuel fill pipe to the fuel fill pipe housing.
- Lower the vehicle.
- Install the fuel fill pipe housing to the fuel fill pipe bolts.
- Install the fuel fill pipe ground strap screw.
- Refill the fuel system.
- Install the fuel filler cap.
- Connect the negative battery cable.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
| • | Tighten the fuel fill hose clamp to 2.5 N·m (22 lb in). |
| • | Tighten the vent hose clamp to 2.5 N·m (22 lb in). |
Tighten
Tighten the fuel fill pipe housing to fuel fill pipe bolts to 2.3 N·m
(20 lb in).
Tighten
Tighten the screw to 9 N·m (80 lb in)
