1. Remove the fuel tank filler cap.
2. Loosen the upper intake manifold cover bolts.



3. Remove the upper intake manifold cover.



4. Open the air bleed valve on top of the fuel manager/filter to release any pressure in the fuel supply system.



5. Remove the element nut by turning the element nut in a counterclockwise direction. If the nut is unable to turn by hand, a strap wrench (oil filter type) may be used to break loose the element nut.



6. Remove the filter by lifting the filter straight up and out of the filter assembly. Draining fuel from the filter assembly to change the filter element is not necessary since the fuel will remain in the filter assemblies cavity.

Important: Make sure the mating surface between the element assembly and the filter assembly is clean before installation.

1. Install the new filter by aligning the widest key slot located under the element assembly cap with the widest key in the header assembly.



2. Push the element, in a downward direction until the mating surfaces make contact.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the element nut.

Tighten
Tighten the element nut securely by hand.

4. Bleed the air from the fuel manager/filter. Refer to Fuel Feed Pipe and Return Pipe Purging .



5. Install the upper intake manifold cover.
6. Install the bolts.

Tighten
Tighten the bolts to 11 N·m (97 lb in).

7. Install fuel tank filler cap.