Removal Procedure
- Raise the vehicle on a hoist.
- Support the rear axle in order to relieve the tension from the rear springs using a suitable jack stand.
- Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
- Remove the upper retaining bolt (6) from the shackle (4).
- Remove the lower retaining bolt (5) from the shackle.
- Remove the shackle from the vehicle.
Installation Procedure
- Install the shackle (4) to the vehicle.
- Install the lower retaining bolt (5) to the shackle.
- Install the upper retaining bolt (6) to the shackle.
- Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
- Remove the jack stands.
- Lower the vehicle.
Use a new bolt and new nut each time the service is performed.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Important: Use a new bolt and new nut each time the service is performed.
Tighten
Tighten the upper shackle retaining bolt and the lower shackle retaining
bolt to 90 N·m (67 lb ft).
