Tools Required

1. Remove the steering column shrouds. Refer to Steering Column Trim Covers Replacement - On Vehicle .



2. Install the J 23653-SIR to the steering shaft and compress the shaft lock shield.
3. Remove the lock shield retainer from the steering column shaft.
4. Remove the J 23653-SIR from the steering shaft.



5. Remove the following parts from the steering shaft:

5.1.	Shaft lock shield (4)

5.2.	Turn signal cancel cam (3)

6. Rotate the steering column lock cylinder to the OFF-LOCK position.



7. Insert a small screwdriver into the slot on the electronic lock module and push down on the park lock cable locking tab and remove park lock cable (1) from the electronic lock module, column shift only.



8. Disconnect the electric park lock (1) electrical connector (2), floorshift only.



9. Unsnap the electric park lock (2) off of the electronic lock module  (1) ,floorshift only.



10. Rotate the key alarm switch connector (1) from the electronic lock module.
11. Disconnect the passlock electrical connector from the electronic lock module.



12. Disconnect the ignition switch (2) from the electronic lock module using the J-42759 .
13. Remove the ignition switch (2) from the electronic lock module (2).
14. Let the ignition switch (2) hang freely.



15. Remove the electronic lock module (1) mounting screws (2).
16. Remove the electronic lock module (1) from the steering column housing.

1. Install the electronic lock module (1) to the steering column housing.
2. Install the electronic lock module(1) mounting screws (2).



3. Install the ignition switch (2) to the electronic lock module (2).



4. Connect the passlock electrical connector (1) from the lock module.
5. Rotate the key alarm switch connector to the electronic lock module.



6. Snap the electric park lock (2) onto the electronic lock module (1), floorshift only.



7. Connect the electric park lock (1) electrical connector (2) floorshift only.



8. Install park lock cable (1) to the electronic lock module, column shift only.



9. Install the following parts to the steering shaft:

9.1.	Turn signal cancel cam (3)

9.2.	Shaft lock shield (4).




10. Install the J 23653-SIR to the steering shaft and compress the shaft lock shield.
11. Install the lock shield retainer to the steering column shaft.
12. Remove the J 23653-SIR from the steering column shaft.
13. Install the steering column shrouds. Refer to Steering Column Trim Covers Replacement - On Vehicle .