GM Service Manual Online
For 1990-2009 cars only

Rear Axle Shaft and/or Gasket Replacement 11 Inch Axle

Removal Procedure


    Object Number: 762332  Size: SH
  1. Remove the axle shaft cover bolts.
  2. Remove the axle shaft cover.
  3. Lightly tap on the axle shaft cover with a soft-faced hammer to loosen the cover.

  4. Insert a bolt into the threaded hole in the axle shaft.

  5. Object Number: 762333  Size: SH
  6. Remove the axle shaft from the axle tube by pulling on the axle shaft and the bolt.
  7. Clean the axle shaft cover and the outside face of the hub assembly of sealant.

Installation Procedure


    Object Number: 762333  Size: SH
  1. Install the axle shaft into the wheel hub.
  2. Carefully guide the axle shaft through the axle tube and into the differential side gear turning the axle shaft as necessary in order to align the splines on the axle shaft with the splines on the differential side gear.

    Important: The axle shaft is properly installed when the splines on the axle shaft are flush with the splines on the hub.

  3. Install the axle shaft flange into the wheel hub.

  4. Object Number: 762460  Size: SH
  5. Install the axle shaft cover gasket.
  6. Install the axle shaft cover.
  7. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  8. Install the axle shaft cover bolts.
  9. Tighten
    Tighten the axle shaft cover bolts to 21 N·m (15 lb ft).

  10. Inspect and add axle lubricant to the axle housing, if necessary. Refer to Lubricant Level Check .