GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2005 🢒 Chevy C Cab/Chassis HD (GMT 400) 🢒 Suspension 🢒 Rear Suspension 🢒 Stabilizer Shaft Link Replacement

Removal Procedure

    Object Number: 590172 Size: SH
  1. Raise the vehicle. Support the vehicle with suitable safety stands. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the following parts from the stabilizer links:
    3. • The link nut (11)
    • The link bolt (7)
    • The link spacer (9) and insulators (6, 8,10)
  3. Inspect the components for wear.

Installation Procedure

    Object Number: 590172 Size: SH
  1. Assemble the following parts. Do not tighten.
    2. 1.1. Install the stabilizer shaft insulators (6, 8,10) and spacer (9).
    1.2. Install the link bolt (7) through the stabilizer shaft, insulators (6, 8,10) and spacer (9).
    1.3. Install the link bolt (7) through the frame and install the upper insulator (6).

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the link nut (11).

    3. Tighten
    Tighten the link nut to 23 N·m (17 lb ft).

  3. Lower the vehicle.