Front Seat Belt Replacement Regular Cab With Bucket Seat

Caution: To help avoid personal injury from unrepaired crash damage to a restraint system, perform the seat belt check for each seat belt system. Replace the seat belt system if there is any doubt about the condition of system components.

Notice: Refer to Servicing and Replacing Seat Belts Notice in the Preface section.

1. Remove the cover from the door pillar anchor plate. Pry up the bottom.



2. Remove the bolt from the door pillar weld nut.



3. Remove the bolt retaining the retractor to the floor panel.
4. Remove the retractor from the vehicle.

1. Install the retractor and belt to the floor.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the bolt through the retractor into the floor panel weld nut.

Tighten
Tighten the bolt to 55 N·m (41 lb ft).




3. Install the bolt through the anchor plate and washer into the door pillar weld nut.

Tighten
Tighten the bolt to 55 N·m (41 lb ft).

4. Install the cover over the door pillar anchor plate.

Front Seat Belt Replacement Regular Cab With Bench seat

Caution: To help avoid personal injury from unrepaired crash damage to a restraint system, perform the seat belt check for each seat belt system. Replace the seat belt system if there is any doubt about the condition of system components.

Notice: Refer to Servicing and Replacing Seat Belts Notice in the Preface section.

1. Remove the cover from the door pillar anchor plate. Pry up the bottom.



2. Remove the bolt from the door pillar weld nut.



3. Remove the bolt retaining the retractor to the floor panel.
4. Remove the retractor from the vehicle.

1. Install the retractor and belt to the floor.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the bolt through the retractor into the floor panel weld nut.

Tighten
Tighten the bolt to 55 N·m (41 lb ft).




3. Install the bolt through the anchor plate and washer into the door pillar weld nut.

Tighten
Tighten the bolt to 55 N·m (41 lb ft).

4. Install the cover over the door pillar anchor plate.