Removal Procedure
- Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Clean all dirt and foreign material from the brake hose and brake pipe fitting.
- Use a backup wrench on the hose fitting, disconnect the brake pipe fitting from the brake hose, then cap or plug the brake pipe fitting end.
- Remove the brake hose retaining clip from the hose mounting bracket.
- Remove the hose from the bracket.
- Remove the brake hose to caliper bolt from the brake caliper.
- Remove the brake hose from the brake caliper.
- Remove and discard the 2 copper brake hose gaskets. These gaskets may be stuck to the brake caliper and/or the brake hose end.
Important: Install a rubber cap or plug to the exposed brake pipe fitting ends in order to prevent brake fluid loss and contamination.
Installation Procedure
- Assemble the 2 New copper brake hose gaskets, and the brake hose bolt to the brake hose.
- Install the brake hose to caliper bolt and the 2 New washers to the brake caliper.
- With the weight of the vehicle on the suspension, install the brake hose into the bracket.
- Install the brake hose retaining clip to the hose mounting bracket.
- Remove the rubber cap or plug from the exposed brake pipe fitting end.
- Connect the brake pipe fitting nut to the brake hose:
- Ensure that the hose does not make contact with any part of the suspension. Check the hose in extreme right and left turn conditions. If the hose makes contact, remove the hose and correct the condition.
- Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding .
- Lower the vehicle.
Important: Install 2 New copper brake hose gaskets.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the bolt to 40 N·m (30 lb ft).
Important: The hose must not be twisted. Make sure the hose is not in contact with any suspension component.
| • | Use a backup wrench on the hose fitting. |
| • | Do not bend the bracket or the pipe. |
Tighten
Tighten the bolt to 25 N·m (18 lb ft).
