Removal Procedure
- Put the shift lever clevis into the neutral position.
- Remove the knee bolster. Refer to
Driver Knee Bolster Panel Replacement
in Instrument
Panel Gages and Console.
- Disconnect the electrical connector.
- Use a small screwdriver to pry the electrical automatic transmission shift
lock control actuator from the steering column jacket assembly.
- Remove the automatic transmission shift lock control actuator from the
steering column.
Installation Procedure
- Install the automatic transmission shift lock control
actuator onto the steering column jacket assembly.
- Connect the electrical connector.
- Adjust the electrical automatic transmission shift
lock control actuator.
| 3.1. | Pull out the tab (1) on the adjuster block side (2) of the
electrical automatic transmission shift lock control actuator. |
| 3.2. | Press on the adjuster block (2) to disengage the adjuster teeth.
Slide the adjuster block (2) as far away from the actuator as possible. |
| 3.3. | Lock the adjuster block in place by pushing inward on the tab (1). |
- Inspect the electrical automatic transmission shift lock control actuator
for the following items:
| 4.1. | The electrical automatic transmission shift lock control actuator must
lock the shift lever clevis when the shift lever clevis is put into the PARK position. |
| 4.2. | Turn the ignition to the ON position and depress the brake pedal in order
to move the gear shift lever out of the PARK position. The actuator will be energized. |
| 4.3. | Readjust the electrical automatic transmission shift lock control actuator
if needed. |
