Removal Procedure
- Remove the instrument cluster bezel.
| • | Four clips across the top edge, and four clips across the bottom
edge, retain the bezel. |
| • | For vehicles equipped with tilt wheel, move the steering column
to the lowest position. |
| • | For vehicles without tilt wheel, you may have to lower the column.
Refer to
Steering Column Replacement
in Steering Wheel and Column. |
| • | Disconnect the electrical connectors from the headlamp switch
and the dimmer control and accessory switches. |
- Remove the four screws that retain the
instrument cluster.
- Remove the instrument cluster from the vehicle.
Keep fingers and other foreign objects away from the flexible circuit
connections.
Installation Procedure
- Install the instrument cluster into the
instrument panel.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the instrument cluster hold-down screws.
Tighten
Tighten the instrument cluster hold-down screws to 2 N·m
(18 lb in).
- Connect the electrical connectors to the headlamp switch and the
dimmer control and accessory switches.
- Install the instrument cluster bezel.
