Ignition Lock Cylinder Replacement On Vehicle

1. Set the front wheels in the straight-ahead position.
2. Set the steering wheel in the LOCK position.
3. Remove the steering column trim covers. Refer to Steering Column Trim Covers Replacement .



4. Turn the ignition lock cylinder to the START position.
5. Using an awl, insert the tip into the ignition lock cylinder access hole (1).
6. Push down and hold the ignition lock cylinder retaining pin.
7. Release the ignition lock cylinder to the RUN position.



8. Remove the ignition lock cylinder by pulling the ignition lock cylinder away from the steering column.

1. Install the ignition lock cylinder into the steering column using the following procedure:

1.1.	Align the positioning locking tab slot on the lock module assembly to the positioning tab on the ignition lock cylinder.

1.2.	Push the lock cylinder in until the locking tab locks in the lock module assembly.

2. Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement .