GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 1998 🢒 Chevy C Pickup - 2WD 🢒 Engine 🢒 Engine Controls - 4.3L 🢒 Control and Shift Solenoids Replacement

Removal Procedure
  1. Remove the oil pan and the oil filter.

    2. Object Number: 14464 Size: SH
  2. Remove the accumulator cover bolts.

    3. Object Number: 14467 Size: SH
  3. Remove the 1-2 accumulator cover.
  4. Remove the piston.
  5. Remove the springs.
  6. Disconnect the component electrical connectors.

    7. Object Number: 13876 Size: SH
  7. Remove the pressure control solenoid retainer bolt/screw.

    8. Object Number: 13880 Size: SH
  8. Remove the pressure control solenoid retainer.
  9. Remove the pressure control solenoid.

    10. Object Number: 13884 Size: SH
  10. Remove the shift solenoid retainers.

    11. Object Number: 13364 Size: SH
  11. Remove the shift solenoids.

    12. Object Number: 13365 Size: SH
  12. Remove the 3-2 control solenoid retainer.

    13. Object Number: 13886 Size: SH
  13. Remove the control solenoid.

Installation Procedure

    Object Number: 13886 Size: SH
  1. Install the 3-2 control solenoid.

    2. Object Number: 13365 Size: SH
  2. Install the 3-2 control solenoid retainer.

    3. Object Number: 13364 Size: SH
  3. Install the shift solenoids.

    4. Object Number: 13884 Size: SH
  4. Install the shift solenoid retainers.

    5. Object Number: 13880 Size: SH
  5. Install the pressure control solenoid.
  6. Install the pressure control solenoid retainer.

    7. Object Number: 13876 Size: SH
  7. Install the pressure control solenoid retainer bolt/screw.

    8. Position the pressure control solenoid with the electrical tabs facing outboard.

  8. Connect the component electrical connectors.

    9. Object Number: 14467 Size: SH
  9. Install the 1-2 accumulator piston to the accumulator cover.

    10. Replace piston seal.

    The piston legs must face toward the case when installed.

  10. Install the 1-2 accumulator springs into the piston.
  11. Install the 1-2 accumulator cover.

    12. Object Number: 14464 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  12. Install the 1-2 accumulator cover bolts.

    13. Tighten
    Tighten the bolts to 11 N·m (97 lb in).

  13. Install the oil pan and the oil filter.