Vehicle Speed Sensor NV3500

1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.



2. Disconnect the electrical connector from the vehicle speed sensor assembly.
3. Place a drain pan under the transmission in order to catch the oil.



4. Remove the following parts:

•

The bolt

•	The vehicle speed sensor

•	The O-ring seal

1. Coat a new O-ring seal with a thin film of transmission oil. Use Synchromesh Transmission Fluid or the equivalent.




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the following parts:

•	The O-ring on the vehicle speed sensor assembly

•	The vehicle speed sensor assembly

•

The bolt

Tighten
Tighten the bolt to 22 N·m (16 lb ft).




3. Install the electrical connector on the vehicle speed sensor assembly.
4. Lower the vehicle.

Vehicle Speed Sensor NV4500

1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Support the vehicle with safety stands.



3. Disconnect the electrical connector from the vehicle speed sensor assembly.
4. Place a suitable container under the transmission in order to catch the fluid.



5. Remove the following parts:

5.1.

One bolt

5.2.	The vehicle speed sensor

5.3.	The O-ring seal

1. Coat a new O-ring seal with a thin film of transmission fluid. Use Castrol Syntorq GL-4 Transmission Fluid or the equivalent.



2. Install the following parts:

2.1.	The O-ring on the vehicle speed sensor assembly

2.2.	The vehicle speed sensor assembly

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2.3.

One bolt

Tighten
Tighten the bolt to 22 N·m (16 lb ft).




3. Install the electrical connector on the vehicle speed sensor assembly.
4. Remove the safety stands.
5. Lower the vehicle.
6. Check the transmission fluid level.