Notice: Ensure all fasteners are securely seated before applying needed torque.
Failure to do so may result in component damage or malfunctioning of steering
column.
- Install the wave washer.
Important:
• | Ensure that the coil assembly is centered. |
• | The coil assembly becomes un-centered under the following conditions: |
- | The steering column is separated from the steering gear and allowed
to rotate. |
- | The centering spring is pushed down (1), letting the hub
rotate while the coil is removed from the steering column. In the event this
occurs, refer toInflatable Restraint Coil Centering -
Off Vehicle (Column Shift And Floor Shift)
in steering wheel and
column. |
- To install the SIR coil assembly, align the block tooth on the race
and upper shaft assembly to the 12 o'clock position.
- Install the pre-centered
coil assembly to the steering column. Remove the centering tab (1) and discard.
Important: Gently pull on the lower coil assembly wire in order to remove any wire
kinks inside of the column assembly. Ensure that there are NO kinks or bends
in the SIR coil assembly wire. If a kink or bend is present, interference
may occur with the shaft lock mechanism. Turning the steering wheel
may cut or damage the wire.
- Install the coil assembly (2) using the following components
for alignment:
• | The horn tower (1) on the canceling cam assembly inner
ring |
• | The projections on the outer ring |
- Install the coil assembly
retaining ring. Ensure that the ring (1) is firmly seated in
the groove on the upper shaft assembly (2).
- Pop the wire harness assembly (4) into the wire strap (5).
- Install the wire harness strap (2) into the upper tilt
head assembly (1).
- Install 3 wire harness straps (3) from the wire harness
assembly.
- Install the multi-function switch lever assembly and the bolt.
Refer to
Multifunction, Turn Signal, and Hazard Switch Replacement - On Vehicle
in Steering Wheel
and Column -- Tilt.
- Install the upper and lower shrouds. Refer to
Steering Column Trim Covers - Assemble - Off Vehicle
in
Steering Wheel and Column -- Tilt.
- Install the tilt lever, if equipped. Refer to
Tilt Lever Replacement - On Vehicle
in Steering Wheel and Column
-- Tilt.
- Install the steering wheel assembly. Refer to
Steering Wheel Replacement
in Steering Wheel and Column
-- Standard or
Steering Wheel Replacement
in Steering Wheel and Column -- Tilt.
- Enable the SIR system. Refer to
Enabling the SIR System
.