Tools Required

J 35748 Oil Pressure Sending Unit Socket

Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.



2. Disconnect the spark plug wires and ignition coil wire from the distributor.



3. Disconnect the camshaft position sensor (CMP) harness connector from the distributor.



4. Remove the distributor cap screws.



5. Remove the distributor cap.




Important: A DTC P1345 will set if the rotor is not reinstalled in the exact position the rotor was in prior to removal.

6. Observe the alignment of the rotor in relation to the distributor base (1).



7. Remove the distributor mounting bolt.



8. Remove the distributor assembly.



9. Disconnect the engine oil pressure sensor harness connector.



10. Remove the engine oil pressure sender with a J 35748 Oil Pressure Sending Unit Socket.



11. Remove the knock sensor harness connector.



12. Remove the knock sensor.

Tools Required

J 35748 Oil Pressure Sending Unit Socket

Important: Do not use the old distributor cap screws. Use replacement screws that have been coated with a thread locking compound. Precoated replacement cap screws can be acquired using P/N 10475922 (pkg of 10 screws).

Notice: Replacement components must be the correct part number for the application. Components requiring the use of the thread locking compound, lubricants, corrosion inhibitors, or sealants are identified in the service procedure. Some replacement components may come with these coatings already applied. Do not use these coatings on components unless specified. These coatings can affect the final torque, which may affect the operation of the component. Use the correct torque specification when installing components in order to avoid damage.

1. Install the knock sensor.

Tighten
Tighten the sensor to 20 N·m (15 lb ft)




2. Connect the knock sensor harness connector.



3. Install the engine oil pressure sender with a J 35748 Oil Pressure Sending Unit Socket.

Tighten
Tighten the sender to 30 N·m (22 lb ft)




4. Connect the engine oil pressure sensor harness connector.




Important: The proper CKP/CMP correlation will be lost if the rotor is not be reinstalled in the same exact position. A DTC P1345 will result from improper distributor shaft alignment.

5. Align the rotor in its original position in relation to the distributor base (1).



6. Install the distributor assembly.



7. Install the distributor mounting bolt.

Tighten
Tighten the bolt to 25 N·m (18 lb ft)




8. Install the distributor cap.



9. Install new distributor cap screws.

Tighten
Tighten the screws to 2.1 N·m (21 lb in)




10. Connect the CMP harness connector.



11. Connect the spark plug wires and ignition coil wire.
12. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.