You must perform a Theft relearn procedure if any of the following components have been replaced:

The above modules, with the exception for the Passlock sensor must also be programmed with each module's own vehicle configuration. See the individual module service manual section.

There are two types of VTD relearn procedures:

Time required, approximately 30 minutes.

1. Ensure that the battery is fully charged.
2. Use the scan tool to clear the DTCs.
3. Turn the ignition switch from the OFF position to the CRANK position allowing the vehicle to try and start. The vehicle will start and then stall.
4. Leave the ignition switch in the ON position while observing the security indicator.
5. When the security indicator turns off, which can take up to 10 minutes, turn the ignition switch off. Wait 10 seconds.
6. Repeat Steps 3-5 2 more times (3 times total).

The BCM and the PCM/VCM will learn the new code on the next start attempt.

Time required, approximately 10 minutes. Refer to PASSLOCK Reprogramming Seed and Key