Tail/Turn Signal Lamp Replacement pickup

1. Ensure the headlamp switch is in the OFF position.



2. Remove the 2 screws retaining the tail/turn signal lamp assembly to the body.
3. Identify the bulb in need of replacement.

•	The top bulb is a parking lamp.

•	The center bulb is a parking, brake, and a turn indicator lamp.

•	The lower bulb is a backup lamp.

4. Turn the socket assembly.
5. Remove the socket assembly from the housing.

1. Turn the socket.
2. Lock the socket in place.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the tail/turn signal lamp assembly to the vehicle with the 2 screws.

Tighten
Tighten the screws to 2 N·m (18 lb. in).




4. Close the endgate.
5. Inspect the operation.

Tail/Turn Signal Lamp Replacement Pickup Step Side

1. Ensure the headlamp switch is in the OFF position.
2. Lower the endgate.



3. Remove the screws retaining the tail/turn signal lamp assembly to the body.
4. Identify the bulb in need of replacement.

•	The top bulb is a parking lamp.

•	The center bulb is a parking, brake, and turn indicator lamp.

•	The lower bulb is a backup lamp.

5. Turn the socket assembly and remove the bulb from the housing.

1. Install the bulb into the socket.
2. Install the socket into the housing turning the socket in order to lock the socket in place.
3. Turn the socket and lock in place.




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

4. Install the tail/turn signal lamp assembly to the vehicle with the screws.

Tighten
Tighten the screws to 2 N·m (18 lb in).

5. Close the endgate.
6. Inspect the operation.