1. Turn the ignition to the ON position with the engine OFF.
2. Ensure the dome lamp override switch is in the OFF position.
3. Connect a scan tool.
4. Using the scan tool, check for any DTCs in the body control module (BCM).

Does the scan tool show any DTCs?

--

Go to Diagnostic System Check - Body Control System in Body Control System

Go to Step 2

1. Close all of the doors.
2. Using the scan tool, read the dome lamp switch status.

Does the scan tool show the switch status as ON?

--

Go to Step 3

Go to Step 4

Replace the BCM. Refer to Body Control Module Replacement in Body Control System.

Is the replacement complete?

--

System OK

--

1. Disconnect the headlamp and panel dimmer switch.
2. Connect a fused jumper wire from terminal E to terminal G.
3. Using the scan tool, read the dome lamp switch status.

Does the scan tool show the switch status as ON?

--

Go to Step 5

Go to Step 6

Replace the headlamp and panel dimmer switch. Refer to Headlamp Switch Replacement .

Is the replacement complete?

--

System OK

--

1. Connect a fused jumper wire from terminal G of the headlamp and panel dimmer switch to ground.
2. Using the scan tool, read the dome lamp switch status.

Does the scan tool show the switch status as ON?

--

Go to Step 7

Go to Step 8

Locate and repair the open in CKT 1850 (BLK) between the headlamp and panel dimmer switch and ground.

Is the repair complete?

--

System OK

--

Locate and repair the open in CKT 1495 (DK BLU/WHT) between the BCM and the headlamp and panel dimmer switch.

If no open is found, Replace the BCM. Refer to Body Control Module Replacement in Body Control System.

Is the repair complete?

--

System OK

--