GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2000 🢒 Chevy C Silverado - 2WD 🢒 HVAC 🢒 Heating, Ventilation and Air Conditioning 🢒 Air Conditioning Evaporator Core Replacement

Removal Procedure
  1. Drain the engine coolant. Refer to Cooling System Draining and Filling in Engine Cooling.
  2. Recover the refrigerant. Refer to Refrigerant Recovery and Recharging .
  3. Remove the heater/vent module. Refer to Heater/Vent Module Replacement .
  4. Remove the HVAC module screws.
  5. Separate the HVAC module.

    6. Object Number: 363774 Size: SH
  6. Remove the evaporator core.

Installation Procedure

    Object Number: 363774 Size: SH
  1. Install the evaporator core.
  2. Install the HVAC module halves.

    3. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the HVAC module screws.

    4. Tighten
    Tighten the HVAC module screws to 1.6 N·m (14 lb in).

  4. Install the heater/vent module. Refer to Heater/Vent Module Replacement .
  5. Refill the engine coolant. Refer to Cooling System Draining and Filling .
  6. Recharge the A/C system. Refer to Refrigerant Recovery and Recharging .