Schematic Reference: Interior Lights Schematics

Did you perform the Lighting Diagnostic System Check?

Go to Step 2

Go to Diagnostic System Check - Lighting Systems

Verify the fault is present.

Does the system operate normally?

Go to Testing for Electrical Intermittents in Wiring Systems

Go to Step 3

1. Ensure the dome lamp override switch is in the OFF position.
2. With the Scan Tool , read the dome override switch status.

Does the scan tool display the switch status as OFF?

Go to Step 5

Go to Step 4

1. Disconnect the headlamp and panel dimmer switch.
2. With the scan tool, read the dome override switch status.

Does the scan tool display the switch status as OFF?

Go to Step 13

Go to Step 10

1. Open the driver's door.
2. With the scan tool, read the driver door jamb switch status.

Does the scan tool display the switch status as Active?

Go to Step 8

Go to Step 6

1. Disconnect the LH mini wedge (door jamb switch).
2. Connect a fused jumper wire between the door jamb switch signal circuit and the ground circuit of the door jamb switch.
3. With the scan tool, read the driver door jamb switch status.

Does the scan tool display the switch status as Active?

Go to Step 14

Go to Step 7

1. Connect a fused jumper wire between the door jamb switch signal circuit and a good ground.
2. With the scan tool, read the driver door jamb switch status.

Does the scan tool display the switch status as Active?

Go to Step 11

Go to Step 12

1. Remove the courtesy lamp relay.
2. Using J 35616 , connect a fused jumper wire between the courtesy lamp output circuit and the ground circuit at the courtesy lamp relay.
3. Open the drivers door.

Do the courtesy lamps light?

Go to Step 15

Go to Step 9

1. Reinstall the courtesy lamp relay.
2. Remove the inadvert power relay.
3. Using J 35616 , connect a fused jumper wire between the fused battery positive circuit and the inadvertent power relay output circuit at the relay socket.
4. Open drivers door.

Do the courtesy lamps light?

Go to Step 16

Go to Step 17

Repair the short to ground in the interior lamp defeat switch output circuit. Refer to Wiring Repairs in Wiring Systems.

If no short is found, replace the BCM. Refer to Body Control Module Replacement in Body Control System.

Did you complete the replacement?

Go to Step 18

--

Repair the open in the ground circuit. Refer to Wiring Repairs in Wiring Systems.

Did you complete the repair?

Go to Step 18

--

Repair the open in the door jamb switch signal circuit between the LH mini wedge and the body control module (BCM). Refer to Wiring Repairs in Wiring Systems.

If no open is found, replace the BCM. Refer to Body Control Module Replacement in Body Control System.

Did you complete the repair?

Go to Step 18

--

Replace the headlamp and panel dimmer switch. Refer to Headlamp Switch Replacement .

Is the repair complete?

Go to Step 18

--

Replace the LH mini wedge (door jamb switch). Refer to Front Side Door Lock Actuator Replacement in doors

Did you complete the replacement?

Go to Step 18

--

Replace the courtesy lamp relay.

Did you complete the replacement?

Go to Step 18

--

Replace the inadvert power relay.

Did you complete the replacement?

Go to Step 18

--

Replace the body control module. Refer to Body Control Module Replacement in Body Control System.

Did you complete the replacement?

Go to Step 18

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 3