Did you review the Wiper/Washer System Circuit Description and perform the necessary inspections?

--

Go to Step 2

Go to Symptoms

1. Turn ignition OFF.
2. Disconnect the windshield wiper motor connector.
3. Turn the ignition ON.
4. Set the wiper/washer switch to LO.
5. Connect a J 35616-200 from wiper motor connector terminal E to ground.

Is the test light on?

--

Go to Step 6

Go to Step 3

Connect a J 35616-200 (backprobe) from terminal E5 at the wiper/washer switch connector C201C to ground.

Is the test light on?

--

Go to Step 4

Go to Step 5

Repair the open in CKT 112.

Is the repair complete?

--

Go to Step 10

--

Replace the wiper/washer switch. Refer to Multifunction, Turn Signal, and Hazard Switch Replacement - On Vehicle .

Is the replacement complete?

--

Go to Step 10

--

Measure the voltage from terminal D to ground at the windshield wiper motor connector using a J 39200 .

Is the voltage within the specified value?

10.5-15 V

Go to Step 7

Go to Step 8

Replace the windshield wiper motor. Refer to Windshield Wiper Motor Replacement .

Is the replacement complete?

--

Go to Step 10

--

Measure the voltage from terminal E8 to ground at the wiper/washer switch connector C201C using a J 39200 .

Is the voltage within the specified value?

10.5-15 V

Go to Step 9

Go to Step 5

Repair the open in CKT 113.

Is the repair complete?

--

Go to Step 10

--

Operate the system in order to verify the repair.

Did you correct the condition?

--

System OK

Go to Symptoms