Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Did you review the Wiper/Washer System Circuit Description and perform the necessary inspections? | -- | Go to Symptoms | |
2 | Do the wipers operate properly? | -- | Diagnose and repair the wiper system. Go to Symptoms . | |
3 | Remove and inspect the W/W PMP fuse. Is the fuse open? | -- | ||
4 | Inspect for a short to ground in CKT 228. Is a short to ground present? | -- | ||
5 | Repair the short to ground in CKT 228. Is the repair complete? | -- | -- | |
6 | Replace the W/W PMP fuse. Is the replacement complete? | -- | -- | |
7 |
Is the test light on? | -- | ||
8 | Replace the wiper/washer switch. Refer to Multifunction, Turn Signal, and Hazard Switch Replacement - On Vehicle . Is the replacement complete? | -- | -- | |
9 |
Is the test light on? | -- | ||
10 | Repair the open in CKT 94. Is the repair complete? | -- | -- | |
11 |
Is the test light on? | -- | ||
12 | Repair the open in CKT 228. Is the repair complete? | -- | -- | |
13 | Connect a J 35616-200 from the washer pump connector (harness side), terminal A to terminal B. Is the test light on? | -- | ||
14 | Replace the windshield washer pump. Refer to Windshield Wiper Motor Replacement . Is the replacement complete? | -- | -- | |
15 | Repair the open in CKT 150. Is the repair complete? | -- | -- | |
16 | Operate the system in order to verify the repair. Did you correct the condition? | -- | System OK | Go to Symptoms |
