Important:
• The body control module (BCM) must be programmed with the proper
RPO configurations before performing learn procedures. See
Body Control Module (BCM) Programming/RPO Configuration
. • If replacing the BCM with a GM Service Parts Operations (SPO)
replacement part, the module will learn passlock™ sensor data code immediately.
The existing PCM however, must learn the new fuel continue password when
the BCM is replaced. • If replacing a PCM with a GM Service Parts Operations (SPO) replacement
part, after programming, these modules will learn the incoming fuel continue
password immediately upon receipt of a password message. Once a password
message is received, and a password is learned, a learn procedure must be
performed to change this password again. A PCM which has been previously
installed in another vehicle will have learned the other vehicle's fuel
continue password and will require a learn procedure after programming to
learn the current vehicle's password.
Use this procedure after replacing:
• | Passlock™ Sensor |
• | BCM |
• | PCM |
Important: The vehicle learns the Passlock™ Sensor Data Code and/or password on the next ignition switch transition from OFF to CRANK. You must turn the ignition OFF before attempting to start the vehicle.